It reads the system variables that correspond to the configuration and the states in order to raise warnings if there is a match to a set of predetermined combinations. The command does not modify any existing variables or system states. The checks are intended to serve as an aid for troubleshooting and maintenance of the system sanity. The checks are designed to look for anything that seems out of place. The command then compiles a list of warning conditions. The show diagnostic sanity command runs a set of predetermined checks on the configuration, along with a combination of certain system states. This catches any latent hardware failure and also resolves any backplane connection issues. In order to resolve this, set the diagnostic boot up level to "complete", and then firmly reseat module 4 in the chassis. This can be related to the first indication of a failing module. This issue can have two causes:Ī poor connection to the backplane (bent connector pin or poor electrical connection), or The error message %CONST_DIAG-SP-4-ERROR_COUNTER_WARNING: Module 4 Error counter exceeds threshold appears on the console of the Catalyst 6500. If you are still unable to determine the problem, or if the error message is not present in the documentation, contact the Cisco Technical Support escalation center. In order to better understand a specific system message, refer to Messages and Recovery Procedures (Catalyst 6500/6000 Cisco IOS system software). Or, use other monitoring stations periodically, such as CiscoWorks and HP OpenView. In order to monitor the logged messages, issue the show logging command. For further configuration information, refer to the Step-by-Step Instructions to Configure IOS Devices section of the document Resource Manager Essentials and Syslog Analysis: How-To. For an overview of the system error messages, refer to System Messages Overview.Įnable the appropriate level of logging, and configure the switch to log the messages to a syslog server. Some of the messages are for informational purposes only and do not indicate an error condition. The system messages are printed on the console if console logging is enabled, or in the syslog if syslog is enabled. Troubleshoot Error Messages in the Syslog or Console Refer to Cisco Technical Tips Conventions for more information on document conventions.
Clone fail read error ez gig iv software#
This document is not restricted to specific software and hardware versions. There are no specific requirements for this document. Troubleshooting Hardware and Related Issues on the MSFC and MSFC2
Clone fail read error ez gig iv series#
Troubleshooting Catalyst 6500/6000 Series Switches Running CatOS on the Supervisor Engine and Cisco IOS on the MSFC Refer to these documents in order to troubleshoot a system that runs Catalyst OS (CatOS) on the Supervisor Engine and Cisco IOS Software on the MSFC: Refer to the Naming Convention for CatOS and Cisco IOS Software Images section of the document System Software Conversion from CatOS to Cisco IOS for Catalyst 6500/6000 Switches in order to understand the naming convention of software images. This document is applicable to Supervisor Engine 1-, 2-, or 720-based Catalyst 6500/6000 switches. This document assumes that you have a problem symptom and that you want to get additional information about it or want to resolve it. Cisco IOS Software refers to the single bundled Cisco IOS image for both the Supervisor Engine and Multilayer Switch Feature Card (MSFC) module. This document describes troubleshooting hardware and related common issues on Catalyst 6500/6000 switches that run Cisco IOS ® system software.
0 kommentar(er)
